#2 Crushed Stone in Florida

Once spread over sandy ground, #2 Crushed Stone forms a loose, open course rather than a tight surface. Its angular pieces are washed and contain no fines, leaving room for water to pass through. That behavior fits construction entrances, culvert runs, and ditches where the base must help carry traffic while water is moving through the site.

On ground with a high water table, avoid relying on a deep excavation to solve drainage. Set this material as a drainage course beneath larger stone where that arrangement is called for, then keep the upper surface suited to the intended use. It can also serve as a heavy base under lanes or equipment pads when an open layer is needed.

Construction Entrances

At a site access point, a substantial layer of angular rock can dislodge mud from truck tires before vehicles continue onto the road.

Culvert & Ditch Lining

Use these weighty stones at culvert openings and in ditches where concentrated runoff needs material that remains in place.

Heavy Base Layers

Install as the bottom layer beneath farm lanes, equipment pads, or yielding ground, then cover it with smaller aggregate.

Drainage Courses

The open voids between pieces let high water volumes pass through and drain beyond the project area.

Stays Put

Its large, weighty pieces are less likely to rut or scatter under vehicle traffic.

Drains Fast

Because it is washed and contains no fines, water has broad spaces to pass between the stones.

Bridges Soft Ground

Large angular rock helps distribute loads when the subgrade is wet or lacks strength.

Low Maintenance

After installation, maintenance generally consists of replenishing the material occasionally.