Should I order material by the ton or by the yard?

It depends on how you measured the job. If you know the volume your pad, bed or trench takes up, order by the yard. If you are matching a weight or comparing base course thicknesses, order by the ton. Limerock base and crushed stone are commonly sold by the ton, while sand, soil and mulch are often easier to figure by the yard.

Which stone is best for drainage in Walton County?

#57 stone is the usual answer for French drains, foundation and pool drainage, and driveway topping. Drain rock and #4 crushed stone suit heavier drainage and trench bottoms, while #8 stone and #89 stone work for fine drainage and pipe bedding. On flat coastal lots, the goal is a washed stone that lets water move instead of sitting.

What do I need to have ready for a bulk delivery?

Have the drop spot cleared and firm enough for a loaded truck, and mark anything overhead that could catch. Let us know about gates, soft lawns, steep drives or tight turns. If the pile is going on the street or a shared drive, check where it can legally sit. Knowing the access before the truck arrives keeps the load where you want it.

Walton County Limerock Base and Gravel Delivery, FL

Florida Rock Supply handles gravel, stone and aggregate delivery in Walton County, FL for two kinds of buyers: contractors who order by the load and homeowners who need one pad or one path done right. Limerock base is the material most of them start with. It is the standard Florida base rock, crushed limestone graded down to fines, and it compacts hard over our loose coastal sand.

From the Gulf beaches at Miramar Beach and Inlet Beach back to the clay hills around DeFuniak Springs, the ground under a project decides what goes on top of it.

Materials Delivered in Walton County

Limerock base, also called limerock or lime rock, does most of the heavy work. Section 204 covers graded aggregate base.

Order it for driveways, parking pads, shed and slab pads and private roads.

Ground Conditions Across Walton County

Walton County spans two ground zones, and each fails in its own way. On the Gulf coast sands around Miramar Beach, Freeport, Inlet Beach and Santa Rosa Beach, the ground is deep, loose, light-colored quartz sand. A thin base on that sand ravels at the edges, ruts under a truck and pumps when it stays wet.

The fix is depth and compaction. Limerock base needs to go down thick enough to bridge the soft layer, then be watered and rolled hard. On low flatwoods and bayfront lots the water table sits close to the surface, so drainage stone under and beside the pad matters as much as the base itself.

Around DeFuniak Springs the ground changes. Sandy or loamy topsoil sits over clayey subsoil, often red or orange, on rolling hills. Clay compacts more easily but drains slowly, so heavy rain runs off slopes and stands on flat ground.

Bare slopes, road cuts, ditches and unpaved drives there wash clayey soil downhill after a downpour, the same process that cut the local ravines.

Work runs year round in both zones. Winter fronts bring soaking rain, summer brings thunderstorms, and hurricane season runs June through November. Clay ground is slow to dry after a heavy rain, so plan base work around the wet stretches.

Delivery Across Walton County

Ordering online starts with a quantity, and the first choice is tons or yards. Sold by the ton, you are ordering the weight the truck carries. Sold by the yard, you are buying volume, which is what a bed, pad or trench actually takes up.

To estimate, multiply length by width by depth in feet, then divide by 27 for cubic yards. For a base course, figure on a compacted depth rather than a loose one, because limerock base settles as it is rolled. If you would rather check the numbers first, use the calculator on the product page.

A bulk delivery is a dump truck dropping material where you want it. Have the spot clear, firm and reachable, with overhead lines and low branches noted. Tell us if the truck has to back in or cross a soft lawn.

We deliver across the county, including Miramar Beach, DeFuniak Springs, Freeport, Inlet Beach and Santa Rosa Beach.

Choosing the Right Material

Ground next door changes the choice. Washington County and Holmes County both sit in the North Florida clay hills and highlands, the same zone as the DeFuniak Springs side of Walton County. Their ground is similar to ours there: sandy or loamy topsoil over clayey subsoil that compacts easily but drains slowly.

For that ground, limerock base still works, but slope protection and ditch work matter more than they do on the coast. RipRap on a cut bank and #57 stone in a French drain handle the runoff that clay sends downhill. Projects in those counties lean toward driveway base and erosion control rather than beach-side pads.

Okaloosa County spans both zones, Panhandle Gulf coast sands and the clay hills, so it mirrors Walton County closely. Ask what the subgrade is before you pick a material, and the answer usually points to one choice.

Size Your Load, Then Place Your Order

Measure the area, settle on a compacted depth, and let the calculator on each product page confirm the tonnage or yardage before you buy. Limerock base, #57 stone, rip rap and topsoil all price and estimate the same way on the site. When the numbers look right, place your order and we will deliver it across Walton County.

Order Limerock Base and Crushed Stone in Walton County, FL