3/8 Inch Crushed Stone for Pathways in Live Oak, FL

Florida Rock Supply handles gravel and aggregate delivery in Live Oak, FL, with limerock base and washed stone for drives, pads, drainage and planting beds. This is limestone country, so most jobs here start with limerock base and finish with a finer stone on top. Sandy ground and summer storms decide how deep each layer needs to be.

Materials for Live Oak Projects

Paths, walkways and garden trails are common Live Oak projects, and fines are what hold those surfaces together. A walkable surface needs crushed stone that locks together and stays firm underfoot instead of rolling loose.

Start the compacted base with Limerock Base, the standard Florida base rock. It is crushed limestone graded down to fines, and it sets hard over sand once it is watered and rolled. Contractors here also call it limerock or lime rock.

Cap the path with Stone Screenings, also called limestone screenings or limerock screenings. These crushed fines make a firm, walkable surface with no loose rock to twist an ankle on.

For a softer look, Walkway Gravel gives a finer finish on garden paths. Under the paver joints, #89 Crushed Stone works as a small washed stone for tight bedding. Where the path crosses a low, wet stretch, Drain Rock keeps water moving instead of pooling.

Ground and Conditions in Live Oak

Ground in this part of Suwannee County is sandy over limestone that sits at or close to the surface on much of the higher ground. On the ridges the sand runs deep, and in the lowlands it runs thin. Either way, a shallow base is the failure you see first.

Too little base shows up as ruts and soft spots. Rain drains fast through sand and porous limestone, so a thin layer never firms up, and a loaded wheel cuts straight through. The fix is depth and compaction: build the base in lifts and roll each one.

Summer afternoon thunderstorms and hurricane season from June through November bring the heaviest water. Sand washes off bare ground into low spots, so edge your path and crown it so runoff leaves instead of sitting.

Delivery to Live Oak and the Surrounding Area

Bulk material is sold by the ton or by the cubic yard, and the two are not the same number. Stone weighs more per yard than soil, so a yard of limerock base and a yard of topsoil order out very differently. Decide which unit you are ordering in before you compare.

To estimate, measure length by width by depth in feet, then convert the depth from inches to feet. That gives you cubic feet, and dividing by 27 gives you cubic yards. For tonnage, your material's weight per yard does the rest.

Order online and we deliver bulk loads to sites in Live Oak and Suwannee County, including Branford, McAlpin, O'Brien and Wellborn. Have the drop spot clear and reachable before the truck arrives.

Questions About Stone and Base in Live Oak

What should I have ready when the truck arrives?

Clear the drop area and make sure the driver can reach it without backing over soft ground or overhead lines. Mark any sprinkler heads, shallow pipes or bed edges you want avoided. If you are spreading by hand, have the wheelbarrow and shovel ready so the pile is not blocking the drive.

What is the best base under pavers in Live Oak?

Limerock base, compacted in lifts, is the standard under pavers here. It is crushed limestone graded down to fines, so it sets hard over Florida sand once it is watered and rolled. Then bed the pavers in limestone screenings, which give a firm, even surface and lock into the joints.

Order Your Path Material for Live Oak

Run your path measurements through the calculator on the product page and it will convert your length, width and depth into the yards or tons you need. Round up a little so you are not short at the end of the run. When you are ready, order limerock base and screenings online for delivery in Live Oak.